When using the traditional hot air drying method or the so-called dehumidification dryer in the market, are you at a loss to deal with the following phenomena?
1. Often troubled by flow marks, blisters, silver bars, cracks, poor transparency, etc.
2. The product is often inspected with the naked eye to be flawless, but due to failure in toughness, tensile strength, impact strength and other physical property tests, the product is returned.
3. Climatic or seasonal changes cause the defective rate to fluctuate, delaying business opportunities.
The above-mentioned problems caused by insufficient drying of plastics, that is, molding, cannot be solved by hot air drying or ordinary dehumidification dryers. Only by choosing a dehumidification dryer with a dew point below -40°C can you ensure quality and fully demonstrate the perfect physical properties of plastics during plastic molding, thereby enhancing your competitiveness.
This honeycomb rotary dehumidifier is mainly used in the plastics industry to dehumidify and dry plastic raw materials, which is different from rotary dehumidifiers that are used for space dehumidification and drying. This dehumidifier needs to be used with a hot air dryer. It is mainly used to generate dry air and use the hot air dryer to remove the moisture inside the plastic particles, so that the moisture content of the plastic particles can be reduced to 0.02% to achieve good molding effects.
differences between single shaft shredders and double shaft shredders
Difference of cross flow square tower & counter flow square tower
What are the advantages of water-cooled chillers？
Masterbatch Frequently Asked Questions
